Airbrush Online

When I Purchased my 1998 cmc rocket 88,was a younger man,now need to re-install turn signals but I foolishly cut off wires & am stuck! I know I need a flasher & relay.A wiring diagram would be great,but cant find one even on-line.The module is still there & thank god I left enough wire to re-solder things but dont know what to solder to what.please HELP?

Is it the same as a stock Harley harness or is it totally different?
A stock harness would have purple for the left signals, brown for the right signals, The flasher goes in between the power and the handlebar switches. I don't think you need a relay. I'll check into it a bit more,

_________________
Ripper
www.ripper1.com

Ripper: thanks,after thinking about it a bit more...I remember all I need is a flasher,dont know how a stock H.D is wired,purple &brown wires are as you described,however this bike has a self canceling module.module has a total of 7 wires & are as follows:red-hot input is still attached,purple-to left switch,grey-not hooked up,black to ground,green & yellow unhooked,brown to right switch.red,purple.grey & black are on one side all others are on other end of module.I did find a "hot fused wire" that has been cut & capped, I think this is hot to flasher?Thanks again for your time& your basic wiring site has been helpfull too....! Ken.